A TX cal seems to have taken care of the power issue. Mike NF4L
> On Feb 2, 2015, at 8:09 AM, Mike Reublin NF4L <[email protected]> wrote: > > I did a poor job on describing the noise level jump. If I switch to ANT2, the > 2nd rec. level goes WAAAY up. > > 73, Mike NF4L > >> On Feb 2, 2015, at 7:38 AM, Mike Reublin NF4L <[email protected]> wrote: >> >> This morning I noticed something strange with #3539. On 80 & 160, tune only >> put out 10W. The level is set for 44W. Full output is 44W, power set to >> 100W. SWR with the AT in bypass is 1.3 on 80M, 1.2 on 160M. All this on >> ANT1. Power out on 40M & up is as expected. >> >> I connected a dummy load to ANT2, and while screwing the connector on, there >> was a huge jump in the volume level on the 2nd receiver. The selected >> antenna is still ANT1. This condition is for all bands. The main receiver >> performs as expected, when ANT2 is selected, noise goes down. >> >> 73, Mike NF4L >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to [email protected] > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
