Consulting Vol XLIX of my station notebook:
In the menus at the top of the Entry Window, go to Config.Configure
Ports etc.
-- In Hardware tab:
-- In the first line, select the COM port for the K3 CAT connection
-- Select "Elecraft K3" from the "Radio" drop down list
-- Leave Digi and CW/Other unchecked
-- Click on Set and select 38400, 8, N, 1, Always OFF, Always OFF.
Everything else is default. Click OK
-- In second line, select COM port for the WinKey
-- Radio=none, Digi=unchecked
-- Check CW/Other
-- Click on Set, and select Always OFF, Always OFF. Check Winkey. Click OK
-- In Winkey tab:
-- Select options you want
-- Set Keying compensation=8
-- "OK" until you're out of Configuration
-- Call CQ
73,
Fred K6DGW
- Northern California Contest Club
- CU in the 50th Running of the Cal QSO Party 3-4 Oct 2015
- www.cqp.org
On 2/2/2015 1:47 PM, Phil Anderson wrote:
The K3 build went nicely, no errors; same for the P3. Now just built
Winkey usb smt to go with N1MM+ to add to the station for contesting.
The keyer kit itself is working just fine as standalone keyer into K3.
However, I'm finding the documentation for integrating N1MM+ the my Dell
system 7.0 and keyer with the K3/P3 a bit much. Here I mean integrating
the N1MM+ software with the above. I'd describe the docs as "circular."
I'm going in circles. I think I have the hardware hooked up right; that
is, the Dell recognizes the serial ports, the USB and COM. What's of
question is the setup/config of the software for SO2V.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
