Steve,
As far as I can determine, no harm would come from making that connection.
IMHO, it would be better to invert the 8R signal, but then I did not
have any 'say' in the DEMI design.
73,
Don W3FPR
On 2/10/2015 4:07 PM, Steve Kavanagh wrote:
I was given a DEMI TIK2 transverter interface board which I would like to install in a K2. It
requires the 8T signal on pin 6 of J13 on the RF board, which was there on early K2s but not on
more recent versions. Can I just connect together the pads marked "X" and "8T"
(on page 9 of the K60XV manual for example) ? Or will this make weird things happen? Obviously
I'd have to break this connection if I wanted to swap in a K60XV instead. 73,Steve VE3SMA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
