On 2/10/2015 9:27 PM, John McBee wrote:
I was getting this error from the kxr3 menu when changing from ATU
port to BNC port I have gotten this error a few times since I have
installed the kxr3. But all usually works. The book said to try to
reload the dsp 1 firmware and dsp2 firmware, so I opened up the k3
utility and tried to reload all firmware. The k3 errored out on
loading firmware and display said MCU LD and lost com port
communications. I could not turn off k3 by pwr button so turned off
pwr supply, now can't get the rig to reset buy holding the shift-lo
button in while pwr up k3. So can't load new firmware yet. Any
suggestions.. I will keep looking in manual for a reset option.
Thanks
John
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
I have read the MCU load error under K3 Firmware Self-Test and what to
do in an error of loading MCU but I have lost communications with the k3
with my serial to usb cable that I normally use and have tried a serial
to serial cable to another computer that still has a serial port- DB9
connections, I have also changed the baud rate to 38400 which it was
before it crashed. No luck with any of these actions. Any help would
be great.
John
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
