Tom, Thanks. I sort of guessed that but I wanted to make sure that there wasn't some source of programming information that I was unaware of.
73, phil, K7PEH > On Feb 16, 2015, at 9:36 AM, Tom <[email protected]> wrote: > > Hi Phil, > While most commands are available in the programming interface, none of the > DSP commands are, neither is there any published means to load the firmware. > Tom > > -----Original Message----- From: Phil Hystad > Sent: Monday, February 16, 2015 11:27 AM > To: Elecraft Reflector > Subject: [Elecraft] K-Line Programming > > Question about programming interface for all the K-Line equipment (including > P3 and KAT500)… > > Are the published programming commands totally complete? In other words, is > the published interface sufficient to rewrite all functions of the > K3/P3/KPA500/KAT500 utility programs including the firmware updates? > > 73, phil, K7PEH > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > > --- > This email is free from viruses and malware because avast! Antivirus > protection is active. > http://www.avast.com > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
