Thanks Don. It's an early K2, serial number 997. Is there anything
unusual about the pot or is it just a standard sized miniature 5K linear?
73, Alan G3XAQ
On 17/02/2015 18:02, Don Wilhelm wrote:
Alan,
If the RF gain pot is worn it will behave that way.
If this is a fairly new K2 I would say SN above 4000, the pot should
not be worn out yet unless the operator used it excessively - so in that
case, look for an unsoldered connection between the RF gain control and
the path to the K2 Control Board.
73,
Don W3FPR
On 2/17/2015 12:44 PM, Alan Ibbetson wrote:
I have just (again) acquired a K2/100. It shows exactly the symptom
below as described in 2009
---
If I move (even very slightly) the rf gain control the audio silences
and the S
meter shows full deflection. After about three seconds or so the receiver
recovers and the s meter returns to normal. This happens wherever teh
rf gain
control is positioned about it's axis.
Any suggestions ?
73 de Vic GW4JUN
-----
It was suggested the RF Gain pot might be noisy but the OP never
followed up. Is this most likely root cause? If so, can someone point
me towards a replacement 5K LIN pot that will fit, ideally sourced
from Newark (Farnell in the UK)?
Thanks a lot,
Alan G3XAQ
--
Alan Ibbetson
[email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
