Thanks everyone for all the replies about my RS232 polling noise. It
turned out to be cable routing. I rerouted the ribbon, the speaker, and
the RF interconnect between the KPA100 and the K2 boards. By moving
these cables away from the IF area and the DB9 rear panel socket I have
completely removed all the PC polling noise.
Regards,
Alan
In message <[EMAIL PROTECTED]>, Alan Ibbetson
<[EMAIL PROTECTED]> writes
My newer laptop does not have a serial port and doesn't run DOS so I
got a MicroHAM CW Keyer. It works fine with my FT1000MP Mk5, but with
my K2/100 I get significant noise (like, S5 on the meter) on all bands
whenever the MicroHAM is polling the K2 RS232 for VFO/Mode data.
Has anyone else seen this problem? MicroHAM support says it's a known
problem with the K2 (?) and suggested asking on this list whether there
are any known fixes.
--
Cheers,
Alan G3XAQ
[EMAIL PROTECTED]
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
