Fault #6 appears to be 'Excessive Driving Power' so it probably wouldn't
hurt to run the TX Gain Calibration again, make sure PWR SET in the menu
is set for Per Band, then check the power settings with the KPA500 on
each band in operate mode.
Although I'm not sure why it would only do it when the 400Hz filter is
selected. You might double check that the 2.8KHz filter is still set as
the TX filter for SSB, CW, and DATA
Mike
KI0HA
On 2/21/2015 17:03, W0MU Mike Fatchett wrote:
I have the 2.8 in slot 2 and the 400 in slot 4...........
Sorry about the mixup.
Mike W0MU
On 2/21/2015 2:56 PM, W0MU Mike Fatchett wrote:
This is easily repeatable on CW.
I have the 2.8 in slot 4 and a 400 hz filter in slot 2.
If I turn the bw down into the 400hz slot 2 position and Xmit. The
amp will fault out with an error 6.
I noticed this in the RTTY contest too but never figured it out.
I wonder if I should try a transmit recalibrate? I just upgraded the
FW on my K3, P3, KAT500 and KPA500 to the latest.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
