Hello, Does anyone have any suggestions on troubleshooting (config or Main or "buttons") menus for this problem.
When I plug in the headphones, there is no audio from the sub receiver (sub has been selected), however, pulling the headphones jack out 1/8 of an inch I receive both Main and Sub in both sides of the headphones. When I remove (deselect sub) there still is no audio on the right ear. I loaded the new firmware, but I am not sure if I lost the "right" ear audio before or after the firmware update. I have reversed the firmware update and got the dual PB back. An email has gone out to Elecraft Support with essentially the same info. Best regards, Jerry ,W1IE -----Original Message----- From: Elecraft [mailto:[email protected]] On Behalf Of Hank P Sent: Sunday, February 22, 2015 2:40 PM To: Elecraft Subject: Re: [Elecraft] K3 no SSB receive On any band CW/DATA/AM receive normal both main and sub dead on SSB either sideband. Can watch the P3 and signals obviously still coming out of the IF but rx goes dead when MODE is tapped to USB . And I mean DEAD - not a whisper phones or speaker RF and AF gain wide open. NB/NR on or off no change. Saw that W4BQF has same issue - but could not find any responses. Hank K7HP ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
