Jerry,
The fact that you can pull the plug out a bit and have proper audio in
both ears speaks to a problem with either the jack in the K3 or the plug
on your headphones. Certainly that cannot be changed by firmware or the
menus, it is simply a matter of something is failing to make proper contact.
Are you using the rear 3.5mm jack or the Front Panel 1/4 inch jack? Are
you using an adapter? Any of those could be at fault.
It might be just a bit of dirt on the contacts in the jack, or a
non-standard ring width on the plug. If using an adapter, then the
adapter is also suspect. It certainly sounds like a mechanical problem
or a plug/jack mismatch to me.
73,
Don W3FPR
On 2/22/2015 5:15 PM, Jerry Knowlton wrote:
Hello,
Does anyone have any suggestions on troubleshooting (config or Main or
"buttons") menus for this problem.
When I plug in the headphones, there is no audio from the sub receiver (sub
has been selected), however, pulling the headphones jack out 1/8 of an inch
I receive both Main and Sub in both sides of the headphones. When I remove
(deselect sub) there still is no audio on the right ear. I loaded the new
firmware, but I am not sure if I lost the "right" ear audio before or after
the firmware update. I have reversed the firmware update and got the dual PB
back.
An email has gone out to Elecraft Support with essentially the same info.
Best regards,
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
