Wayne,
Will other radios that have the revised synthesizer board upgraded in the field
need to perform the receive gain calibration in order to correct the AGC
threshold issue as well?
Is this something that will change upon installing the new board?
73,
Rob
KB2KUU
Sent: Tuesday, February 24, 2015 4:57:23 PM
Subject: Re: [Elecraft] FW: Sherwood Engineering Tests
Just to complete the point about this: The K3 tested probably didn't have its
S-meter calibration ("RX gain cal") completed before we sent it to Rob, an
oversight on our part. This procedure is fully automated by the K3 Utility
program, and definitely would have corrected the sensitivity threshold issue
Rob observed.
73,
Wayne
N6KR
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
