I just built a K3 (#8858) with the new synthesizer, and did the milliwatt
calibration without a hitch. I set it for 1.5 mw max output, but possibly
you did not crank the power up high enough when you started. I made that
mistake reading the power level and got low output. I used a power meter
and am seeing 1.0 Milliwatt out on three transverter bands with the K3 dial
indicating 0 dBm.
Dave K1WHS
----- Original Message -----
From: "Ken Roberson via Elecraft" <[email protected]>
To: "Elecraft Reflector" <[email protected]>
Sent: Wednesday, February 25, 2015 11:00 PM
Subject: [Elecraft] K3_KSYN3A_Synthesizer
Anyone else having trouble with milliwatt TX gain Cal using the new
synthesizer boardOr is it just me.Also on the RF power out only one bar is
lite up.If I set power to 0 dbm (1 milliwatt) it only shows -12.0 dbm (
.06 mw)
Thanks
Ken K5DNL/WG2XXM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
