You need to re-do the power calibration using the
K3 Utility. See the document for the Synth board.
Phil W7OX
On 2/28/15 3:53 PM, David Inger wrote:
I just updated the K3 firmware to 5.10 since I
am about to order the new synth board. When I
restarted the radio after the upload, the
following problem occurred:
When I press the TUNE button, the radio shows
about 8 watts of power. If I turn the power
control up, the display defaults back to 8
watts. In the config menu I have the tune power
set to 20 watts.
I reloaded the firmware to make sure there
wasn't a glitch in the loading. The same
problem still occurs.
The only other troubleshooting I did was to
change the TX ALC (in the config menu) to "OFF"
When I tune up with the TX ALC off, I can get
full power out from the radio, so I assume that
I do not have a component failure problem.
Has anyone experienced this or know of any
settings which I may have inadvertently changed?
73 de K6SBA
David in Santa Barbara, CA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
