If that's a real problem, install 5.10, do the
calibration then move on to 5.14. You only need
to do the 50 W cal once, they say.
Phil W7OX
On 3/6/15 9:56 PM, Dave Anderson, K4SV via
Elecraft wrote:
Hi All,
I just installed the 5.14 in my K3 and when I ran the 5 and 50 watt TX calibration I kept
getting "Calibration power settled at " 3.495.72;" and it would abort.
It appears that during this calibration procedure VFO B is being used. When it
got to 80 meters it would abort. My VFO B was set to 3495.72, which is out of
band and being out of band I do not think the transmitter will transmit RF
power. This caused the abort.
Perhaps the Calibration software should set the VFOs in band before preforming
the calibration.
Once the VFO was set in band all is well.
Best 73 Dave Anderson, K4SVTryon, NC 828 777-5088 WWW.K4SV.NET
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
