Mark,
Set the K2 ATU menu parameter to CALP or CALS depending on whether you
want to read the Power or SWR between the K2 and the KXPA100.
Those two setting "bypass" the KAT2 (except for any residual reactance).
CALP will not work because that setting retains the last used L/C
combination.
73,
Don W3FPR
On 3/31/2015 2:24 PM, Mark Raybould wrote:
I have built, installed and tested a keying circuit and followed the
instructions to interface the KXPA100 with the "Basic Operation with any
Transceiver". My KX3 requires PA Mode to be On allowing all antenna
matching to be done by the KXPA100. With the K2 and its KAT2 ATU, I cannot
identify how to bypass the ATU and allow the KXPA100's ATU to do the
antenna matching. I have previously adjusted the KXPA100's ALC to
accommodate an FT817.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
