I am down to the part where I put the Sub receiver enclosure into the K3 and mate with the pins connecting the Subin and Subout boards to the enclosure. But - Once I set it in the rig, I can't see if the pins on these connectors are properly aligned. There is not a good viewing angle It looks ok but I could be off to one side by a pin or two or miss the connector altogether. The long screws that pass all the way through the enclosure, mate up with the standoff on the main receiver board.
Any way to know if I did it right before I complete the installation and plug it in? 73, Ron, K5HM [email protected] www.qrz.com/db/k5hm Excelsior! ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
