Hey! I have an Elecraft K2, serial number 7535, with the following options installed: KSB2, KNB2, KIO2, KAT2, KBT2, and K160RX. I just installed the K160RX board tonight after sitting on the kit for about a year and finally set out to build it today. Once I installed it I did the basic checks and it is receiving on 160m and the board appears to work just fine. The problem is that I noticed that the rig now doesn't always remember it's prior state if I power cycle it. Previously, if I turned my K2 on, changed frequency with the VFO knob, turned it off and turned it back on, it would remember the frequency I had set it to. Now it reverts to the frequency it held when I last turned it on unless I do something like change the operating mode at the new frequency. In that case, it remembers the frequency where I changed modes when I power-cycle the rig. I do not remember this behavior prior to installing the K160RX.
Everything else about the rig seems to be working fine and the 160m board seems to be working well. I can receive, transmit, and use the receive antenna. My question is: Is this an EEPROM problem, and if so, what is a likely cause and how do I address it? Sincerely, Joseph, KI4ITG -- View this message in context: http://elecraft.365791.n2.nabble.com/K2-EEPROM-Problem-tp7603680.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
