Harry, Be aware that the preamp does not come back on. I encounter this problem periodically when contesting in the UK (6m UKAC) as I have 2 very strong stations nearby and while tuning through the band if I happen to be on frequency when one of them transmits AND our antennas are pointing roughly at each other the KX3 does the full close down as David describes. On odd occasions I can be working someone near the noise level and one of the locals fires up close to my frequency, this shuts everything down and by the time I've recovered the DX station can have gone. I am looking into using an external 6m preamp but I will probably experience the same issue.
Best of luck. Andrew G8BYB -----Original Message----- From: Elecraft [mailto:] On Behalf Of David Anderson Sent: 05 June 2015 08:15 To: Elecraft Reflector Subject: Re: [Elecraft] KX3 Receiver Overload Protection? Harry, Yes it appears to have from Page 43 of the owners manual: HI RFI warning, preamp turns off, or RX icon turns on: The KX3 protects itself from high received signal levels. First, the preamp is turned off, if it was on. (You may be able to avoid this by using the 10-dB preamp rather than the 20-dB preamp on the current band. See MENU:PREAMP.) The second step taken by the KX3, if necessary, is to turn on a 15-dB attenuator stage in the I.F. section, ahead of the receiver s A- to-D converter. The receive overload icon (RX), near the ANT icon, will turn on. Once signals return to a safe level for 5 seconds, this attenuator will be turned back off. Also see COR (next item). ? Carrier-operated relay activated (a relay is heard, and the RX icon turns on): The carrier-operated- relay (COR) may be activated due to the signal from a nearby transmitter. This is usually due to close proximity between your antenna and the other station s antenna. The COR is actually the relay for the present low-pass filter. When the relay opens, signals will drop by 40 to 60 dB, protecting the KX3. The relay will close again shortly after the signal drops. If the COR is being repeatedly activated, try moving the antennas farther apart. You can also increase the COR threshold, at your discretion; see MENU:COR LVL. 73 David Anderson GM4JJJ > On 5 Jun 2015, at 03:16, Harry Yingst via Elecraft <[email protected]> > wrote: > > Does the KX3 have any form of Reciever Overload protection like the K3 does? > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
