I'm not at home to check, but isn't there a CONFIG: setting required for that? 73, Guy K2AV
On Saturday, June 6, 2015, Jim Sheldon <[email protected]> wrote: > I have exactly the same problem here. My K3 doesn't recognize the KXV3B. > I triple checked the install. Funny, but the RX-IN works and my original > VLF mod works fine and it depends on the XV3's RX-IN jack so contrary to my > thinking I have a defective module, I suspect a problem in FW beta 5.26 > that doesn't show up on the factory lab's K3's. Mine's #5027. > > Jim, W0EB > > Sent from my iPad > > > On Jun 6, 2015, at 12:23 PM, Sebastian <[email protected] > <javascript:;>> wrote: > > > > I received today the new KXV3B module, and installed it in my K3 serial > number 05864, using K3 Utility Revision 1.15.5.1. > > > > I also updated my K3 firmware, to revision 05.26. I completed the > Milliwatt TX Gain Calibration (since I also have an XV222). For good > measure, I also completed both the 5 and 50 watt calibration, using an old > Heathkit Cantenna. All of those completed with no errors. > > > > However, upon powering up the K3, I see the ‘ERR XV3’ message. > > > > I have twice removed and reinstalled the module, everything visually > appears to be ok. Since I had the original KXV3 module, I did not open the > bottom of the case, and I used the same TMP cable. > > > > Using the menu settings, I show that PREAMP2 is off, it cannot be > changed. KXV3 is ‘nor'; I can however cycle through ’not inSt’ and ’tESt’. > ATTEN is 10 db and also cannot be changed. > > > > What puzzles me is that my 222 MHz transverter appears to be > functioning, which of course is installed to the KXV3B module. And the IF > Output port is functioning since I have it installed with an external SDR > (Elad FDM-S1). Additionally, while I do not have a different antenna for > receive, the RX ANT switch appears to be working, as pressing it heavily > attenuates and/or removes signals completely. > > > > Since it is the weekend and I won’t be able to reach Elecraft, I would > appreciate any suggestions, or perhaps something that I may have missed > that I did not describe above. > > > > 73 de Sebastian, W4AS > > > > ______________________________________________________________ > > Elecraft mailing list > > Home: http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/mmfaq.htm > > Post: mailto:[email protected] <javascript:;> > > > > This list hosted by: http://www.qsl.net > > Please help support this email list: http://www.qsl.net/donate.html > > Message delivered to [email protected] <javascript:;> > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] <javascript:;> > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] <javascript:;> -- Sent via Gmail Mobile on my iPhone ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
