Just now updating an older K3 with 5.14 using an old winXP machine. The 50W cal went as expected, the 5w cal gives me an error message: ERR TXG. starting on 160. During calibration it only reaches 3.3W at 1.1:1 SWR. I can go an adjust to 5w and it reads 1.0:1 when using a manual key. Tried the calibration again at this point and it made it through 160 and hung on 3.750 MHz, same readings and issue.
I can set the rig and run CW fine @ 5w. calibration doesn't work. Haven't tried going back to the old firmware, but see not reason the new FW shouldn't work. Any suggestions? Thanks, Julius n2wn ----- Julius Fazekas N2WN Tennessee Contest Group http://www.k4ro.net/tcg/index.html Tennessee QSO Party http://www.tnqp.org/ Elecraft K2 #4455 Elecraft K3/100 #366 Elecraft K3/100 -- View this message in context: http://elecraft.365791.n2.nabble.com/ERR-TXG-in-5W-calibration-mode-tp7603793.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
