Right. If you are in fixed-tune mode the averaging does not reset
except when the VFO runs off the edge of the screen. In tracking mode
the averaging resets every time the VFO moves more than about one pixel
on the display.
Alan N1AL
On 06/16/2015 12:07 PM, Eric Swartz - WA6HHQ, Elecraft wrote:
The RX noise floor in the K3 is not likely changing in this case. If you
are using signal averaging on the PX3, the average resets each time you
change frequency. As a result the noise floor will be non-averaged
during continuous tuning and appear higher. Once you stop it will
average over the number of passes you have set and return to its
previous lower value.
73,
Eric
/elecraft.com/
On 6/16/2015 9:22 AM, Phil Wheeler wrote:
No such problem here. Encoder noise?
Phil W7OX
On 6/16/15 8:54 AM, GDR wrote:
While tuning the KX3 I've noticed the noise floor jump up on the PX3.
Seems to do it on all bands. Is this normal? Anyone have any idea
about when fixed mode tuning will be issued in non beta form?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
