Has anyone experienced this? I have tested using DXLabs Commander
directly and through LPBridge, N1MM direct and through LPB and the
results are the same.
Put the rig into AFSK A 45 BPS using the software, check data mode using
the DATA MD button and it is correct. Press A>B button twice, the
frequency is transferred but the "A > B all" never comes up. Swap
operating VFOs and the mode is now DATA A, swap operating VFO's again
(Should now have the original frequency and mode of AFSK A 45 BPS) the
mode is now DATA A. Further testing reveals that this will occur just
by changing VFOs using the A/B button.
If you set the mode using DATA MD and the VFO B knob then Press A>B
button twice the frequency and mode is transferred to the B. More
testing shows that changing the mode using DATA MD and the VFO B Knob
actually changes the mode in both VFOs/Receivers.
I then tried setting the mode in both VFOs using the following commands
in a DXLabs Commander Macro. (The PC020 is to give me 20Watts output)
'k31;md$6;dt$1;bw$0040;is$2210;md6;dt1;bw0040;is2210;PC020;
This sets the VFO A to AFSK A 45 BPS, if I put the VFO B/Sub receiver
commands second then VFO A resets to DATA A.
Please what am I doing wrong? I would like to be able to select RTTY
and have both VFOs in AFSK A 45 BPS. Please no responses saying I
should be using FSK.
Cheers
Greg
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
