It would seem that you have purchased a K2 that was not working as it
should. If it was advertized as a fully working radio, you may have
recourse with the seller for either a refund or a repair. OTOH, if the
seller did not state that it was working properly, you may have to
investigate and fix it yourself.
Normally, the K2 will not go to a display of the power output - it
should come up in receive. Disconnect everything from the K2 except for
the power cord and the antenna connection. To help with diagnosing the
problem, connect the K2 to a dummy load.
If this is a K2/100 (with KPA100). connect the dummy load to the SO-239
jack. If a K2/10, connect the dummy load to the ANT1 jack on the upper
rear panel if the KAT2 is installed, or to the lower rear panel ANT BNC
jack if the KAT2 is not installed.
If you want to troubleshoot it yourself, you can email me directly and I
can help. Please include the configuration and installed options for
your K2 as well as the serial number.
73,
Don W3FPR
On 7/7/2015 6:08 PM, Mauricio Fernandez via Elecraft wrote:
Hello
I'm just new in the Elecraft world. Recently I purchase in Ebay a K2 Serial
4401. The problem is that when I connect the radio to the power and press the
switch button it turn on but immediately turns off, it shows the word
elecraft, it reads the frequency and when goes to the power display PO and then
and then goes off.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
