Hi,
That surely is a solution. I have a desk mic, Kenwood MC60 and use via
extension cables either a Yamaha CM500 or Heil to the rear Jacks when I want to
use a headset boom mic. it is a FP to rear panel switch.
However, I have always thought that all the parameters for that change
should be stored so the change is seamless. Gain, bias, EQ, compression etc, Be
pretty much set and forget.
I'll confess to not knowing all involved in doing it but to the Elecraft
staff that knows, this is a HINT that may possibly be added to the list.
73,
Bob
K2TK ex KN2TKR (1956) & K2TKR
On 7/21/2015 1:03 PM, Don Wilhelm wrote:
Todd,
You would have to write a couple macros.
73,
Don W3FPR
On 7/21/2015 12:56 PM, todd ruby wrote:
I have 2 very different microphones each of which would need its own TX EQ
settings that would be very different. Is it possible to save each of them
and be able to “toggle” back and forth between the settings if I changed mics?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
