Unless you have a variety of microphones from various transceiver
manufacturers *and* like to swap microphones often, I don't see much
sense in the IMA. Just wire the K2 microphone jack for the Elecraft
configuration and re-wire the microphone plugs for that pinout.
OTOH, if you still have transceivers that use those microphones and
cannot easily re-wire the mic plugs, then the IMA makes sense if you
want to swap the mics around.
Most hams pick one microphone and use it with the K2, so there is
normally no need to swap the IMA connections - just wire the normal K2
microphone configuration for the chosen microphone.
On 7/26/2015 11:23 AM, Gary Marklund wrote:
Floyd,
I just did some snooping around their site and found this under "contact
us", http://www.unpcbs.com/us/#contact.
Hope you find one. I built my K2 with both the unpcbs Rework Eliminator and
the IMA. Makes life a lot easier.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
