Tighe,
Check the plastic covering on the batteries carefully, you will likely
find one where the battery case metal is exposed.
Also check the screws mounting the battery holders - the screwheads
should not be able to contact the batteries, but I think you will find
that your screws project too far into the battery compartment.
73,
Don W3FPR
On 8/1/2015 8:41 AM, Tighe Kuykendall wrote:
When I started to reinsert the cells this morning I noticed the spring
end of one cell slot had melted plastic in the spring and the spring
is pushed through the end of the holder almost touching the large cap
on the filter board. I almost certainly have a bad cell, now to
figure out which one.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
