Jobst,
The person who suggested the 4 port switch was none other than Alan
Bloom N1AL - who is the principle P3 designer.
If the power is a problem, I would think he would have mentioned it.
73,
Don W3FPR
On 8/3/2015 9:15 AM, Jobst Vandrey wrote:
FYI
When I was a volunteer at the Elecraft booth in Dayton, the question of
multiple sensors was raised a number of times. During one such discussion,
an individual from Elecraft seemed to indicate that if a switch was to be
built, each sensor in the chain needed to have continuous power.
His take was to switch the signal lines only and leave power to all sensors
at all times. For this reason, he did not recommend a simple off the shelf
switch that transferred all 8 lines.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
