The P3 TX monitor automatically detects what type of sensor is
installed. The sensor includes a resistor connected to one of the
connector pins. The P3 reads the resistor value to figure out which
sensor (200W HF, 2 kW HF or VHF) is installed.
Alan N1AL
On 08/05/2015 07:56 AM, hsherriff wrote:
Received mine yesterday. Was thinking of making a switching box to switch
between sensors. Looking at the manual, looks like you need to tell the P3 the
span of the current sensor. Could do this via a arduino but the programmer's
manual hasn't been updated for the TXmonitor. Anyone know the commands
associated with the monitor functions?
Harlan NC3C
Sent from my Verizon Wireless 4G LTE smartphone
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
