Regretfully thats normal Stan. Independent VFO mode setting is facility
that I would dearly like to have though.
Trev G3ZYY
In message <[EMAIL PROTECTED]>, Stan Rife
<[EMAIL PROTECTED]> writes
I don't think I have a problem, it is more likely operator error. On
any given band, when I switch from VFO A to B, the mode does not change to
what I had previously set VFO B to. If I am LSB in VFO A and I switch to VFO
B, I set the mode to CW, tune around for a while, then go back to VFO A and
it remains in CW mode. It doesn't switch back to LSB for VFO A. Is this
normal? I thought I remembered that the mode was saved for each VFO.
I guess I need to read the manual again, after 2 years.
Stan Rife
W5EWA
Houston, TX
K2 S/N 4216
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
--
Trevor Day
UKSMG #217
www.uksmg.org
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
