There was a thread on this relating to the main tuning knob a while back. The suggestion was to cut a felt washer and put this behind the main knob. Smaller than the main tuning knob of course. I did this and it works fine. 73, Art W6KY K1-4 www.w6ky.com
--- "Darwin, Keith" <[EMAIL PROTECTED]> wrote: > The knobs on my K1 have a bit of a loose feel to me. > Also, when I press > the display button (upper left) the display itself > shifts just a bit. > Should I disassemble and check the various fasteners > to be sure they're > tight or is this just the way the rig is? No I did > not build it. > > I did take the VFO knob off and snugged down the > 10-turn pot's mounting > nut. It was a bit better after that. > > And the batter carrier is just loose in there. When > you put the top on > it snugs down but take the top off and the metal > bracket is relatively > free to move. Is this normal? Again, having not > built it and having > not taken the time to check the manual I'm clueless. > > - Keith KD1E - > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
