Have you checked the owner's manual? Gain for the DVR can be set differently. You didn't indicate which radio you have. But the K3S manual, Page 30. While speaking into the mic, adjust MON for the desired level. (DVR playback level can be set differently; see CONFIG:TX DVR).
-----Original Message----- From: Elecraft [mailto:[email protected]] On Behalf Of [email protected] Sent: Friday, September 04, 2015 12:31 PM To: [email protected] Subject: [Elecraft] SSB Transmit Problems:K3 Good Afternoon, This is Mark Griffin, KB3Z. I just installed the KDVR and used config to turn it on and it did. But, for some reason when I key my microphone I am not getting any power output or ALC bars. I have it on transmit normal and the microphone gain has been turned up and down and no change. When I depress the XMIT/Tune button it gives me power output. Now, I realize that is a CW Signal. Also, when I use CW it works just fine. I don't understand why this is happening. It worked just fine before I installed the KDVR. I also tried disabling it via config and that didn't do any positive. Any suggestions, would be very much appreciated. Mark Griffin, KB3Z ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
