On Fri,9/4/2015 8:30 PM, [email protected] wrote:
Good Evening, I have a Heil HM-12 and what like to connect the microphone to the K3 Microphone connection in the rear of the radio. It would be a XLR 4 to a 1/8" mini plug. I don't know if Heil even makes such a cable.
You're a ham, pull out your soldering iron, and the manuals for the K3 and the headset to see what pins are used for mic and earphones and make your own. XLR4 connectors are widely available and easy to wire. So are 1/8-in plugs if you buy good brands like Switchcraft and Neutrik. My favorite vendor is Full Compass. Part numbers for the 1/8-in plugs are near the end of
http://k9yc.com/GroundingAndAudio.pdf
From what I hear most headsets that heil manufactures has a 1/8" mini plug at the end of the cable. I installed a DVK this morning and now the microphone connector in the front of my K3 does not work. Per Elecraft it has something to do with the DSP Board. Of course if I connect the microphone to the rear jack it bypasses the DSP board.
Can't help you with that part of it. I use Yamaha CM500, which plugs into the rear panel connecters. Far superior and MUCH cheaper.
73, Jim K9YC ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
