I am trying to understand the SET/GET protocol to serially communicate with the
K3.
I am experimenting with "FA;" which will retrieve the VFO A frequency. After I
send the command, I get back responses three bytes at a time which I accumulate
in a ring buffer until the response is complete. Sometimes I get the correct
frequency in the response, sometimes only an "FA". Manual frequency change
from the K3's front panel does not seem to be acknowledged. FA followed by the
frequency does effect a frequency change.
Is there a use group dedicated to UART K3 control?
Thanks, Russ KD4JO
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
