George: Other than the specific instructions needed to connect the K3/IO-Mini to a K3 trough a Remote Rig device, there is nothing different about setting up and operating the K3/IO-Mini than there is in operating the target K3 itself. Keep in mind that the front panel of the K3/IO-mini (including all knobs, menus, etc.) directly controls the corresponding settings of the “remote” (or “target”) K3 that it is connected to. When you change a setting on the K3/IO-Mini, it is actually changing the settings on the target K3. If you go into the configuration menus, you’re changing the configuration of the target K3.
The only exception off hand that I can think of to this general statement is that K3 must be set for “rear panel” microphone so that the mic feed that is coming from the “remote” K3/IO-Mini to the target K3 which in fact is fed to the rear panel connection of the target K3, is utilized. Otherwise, if a front panel mic source is selected, the audio will not be fed into the target K3 from the K3/IO-Mini. The real question is whether the operator is familiar with using a K3 and knows how to configure settings to meet their needs. Thus, reviewing the K3 operating manual makes much sense since that is what is being controlled by the K3/IO-Mini. My comments are based upon using the K3/IO-Mini via remote rig directly to my remote rig controller at the target K3 (e.g. the 1258MK II system) and NOT using remotehams.com service. I am not familiar with remotehams.com setup, but presume that the same concepts apply. Hope this helps, Barry Baines, WD4ASW Westborough, MA Folkston, GA (Currently in Shelby, NC) On Sep 5, 2015, at 11:10 PM, George via Elecraft <[email protected]> wrote: > > > I am setting up a K3/0-Mini for a friend who will use it to operate remote > stations accessible via remotehams.com service. > > The K3/0-Mini was delivered with an Owner's Manual. The manual is limited > to describing how to set up the Mini to work with a PC, how to operate > with the RemoteRig 1258 MKII System (which we are not using), and how to > update the Mini's firmware. The Owner's Manual does not contain any > information about how to use all of the controls on the Mini, or any > information > about its Menu and Config selections. > > Since the person who will be using the Mini is not familiar with at all > with the Mini, or its big brother, a K3, we will need a user-oriented manual > that provides the all the information that an operator will need to know. I > can download copy of a K3 manual, however, I don't know if the > explanations described for a K3 also pertain to the functions of the > K3/0_Mini. > > Please let me know if there is a more complete user-oriented Operator's > Manual for the MIni, or will the K3 manual correctly explain all the > functions of the Mini? > > Thanks, George. > > George Wagner, K5KG > Sarasota, FL 34242 > 941-400-1960 > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
