I have an HP 3314a synthesized function generator that is in very good shape electrically. However, it is missing the two front feet and the front bail. Does anyone know a good source or forum for getting old HP parts? I have had good success in getting old Tek parts, but googling on the internet has not turned up a comparable source for HP equipment. I am about to restore a Fluke 6080A/AN signal generator, so if there is a good source for Fluke, that would be useful, too.
Thanks, Howard W. Ashcraft, Jr. Hanson, Bridgett, Marcus, Vlahos & Rudy 333 Market Street, 21st Fl. San Francisco, CA 94105 ph: 415.995.5073 fax: 415.541.9366 e: [EMAIL PROTECTED] ***************************** This communication, including any attachments, is confidential and may be protected by privilege. If you are not the intended recipient, any use, dissemination, distribution, or copying of this communication is strictly prohibited. If you have received this communication in error, please immediately notify the sender by telephone or email, and permanently delete all copies, electronic or other, you may have. To ensure compliance with requirements imposed by the IRS, we inform you that any tax advice contained in this communication (including any attachments) was not intended or written to be used, and cannot be used, for the purpose of (i) avoiding penalties under the Internal Revenue Code or (ii) promoting, marketing or recommending to another party any transaction or matter addressed herein. The foregoing applies even if this notice is imbedded in a message that is forwarded or attached. ***************************** _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
