Frank,
Unfortunately, the mic plug wiring is different than that for the MH2.
Can I assume that it is one of Heil's microphones that use an adapter?
If so, replace the adapter with the one used for Kenwood (red band).
Since it is an Icom microphone, it likely needs bias, so the resistor
added to the back of the K2 microphone jack can stay in place.
73,
Don W3FPR
On 9/16/2015 1:35 PM, [email protected] wrote:
Hi folks,
I have just been handed a Heil mic wired for 8 pin Icom.
Anyone know if the Icom 8pin is pin for pin compatible with a K2 that is wired
for an MH-2?
Not that I need another mic as I am a CW guy but… I have been on SSB since Don
aligned it and was wondering if I can “just plug it in”.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
