Last night, I turned on my K3/KAT500/KPA500 as normal and upon CW key up, all the Power (W) LEDs lit up across the scale. The Fault LED was not lit. The VSWR was good. The KPA500 reads 640 watts ?? Pout with nominal drive power (15 watts) from the K3. The CUR is not reading any current. This happens on all bands 160 to 6M. All was working yesterday with no problems. I took the KAT500 out of the chain and ran the K3 directly into the amp input and then the amp output into a high power dummy load/watt meter. I only read the K3 nominal power out (set to 15 watts) on the watt meter.
I re-seated all the cables between the rig/tuner/PA. Has anyone experienced this on their KPA500? Roger W5RDW Murphy, TX ----- Roger W5RDW -- View this message in context: http://elecraft.365791.n2.nabble.com/KPA500-S-N-82-Power-Out-Problem-tp7607839.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
