I folks,
Just turned on my K3/100, SN8600 series, rig but I now have no receive
plus no transmit RF out. And, CQWW RTTY is in a few days. The K3 worked
perfectly yesterday but today no RX, no TX, other than that single (non
RF) bar on RF out when keyed. It is not in Test mode, not in Transverter
mode. Just shut down yesterday, turn on today and nothing. The Pre-Amp
on/off amplifies the noise, so it looks like the RX is working just has
no antenna input. It is not antennas, coax etc as the K2/100 sitting
next to the K3 works perfectly on all bands/antennas. Yes, I did check
it directly to the same antenna as the K2. It feels like a PIN diode
problem to me. Any ideas I may have missed.
Thanks, W1ZK
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
