Mike, Unless it was expanded recently, the K1 can be set to any of the 9 HF bands, but it only has memory slots for 6 of them - one can choose any 6 of the 9 available bands.
You are correct that only one correction factor for any one band is available. 73, Don W3FPR > -----Original Message----- > Don wrote: > > > Note that the K1 will remember 6 bands... > > It is my understanding that the K1 will store *one* display > calibration correction for each of the HF bands that can be > assigned to a K1 band. Since each K1 band can be assigned to any > of the nine HF bands, I believe that the K1 can "remember" nine > different band LCD corrections. > > The correction is stored in the front panel MPU system, and not > on a filter board. This causes a minor problem if two or more > filter boards are used in a K1 that duplicate the same band on > each (like a 80/40m two-band board and a 40/30/20/15m four-band > board). Only one correction for 40m can be stored, so one of the > filter boards will result in a slightly inaccurate LCD display > unless the 40m hetrodyne crystals on both filter boards oscillate > within about 100 Hz of each other. > > 73, > Mike / KK5F _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
