John,
The VFO B has no direct relationship to the subRX. The K3 simply has 2
VFOs - try to think of it that way rather than anything about the subRX.
While it is a fact that with the subRX installed, VFO B is normally used
for tuning the subRX, but that can be altered.
Without the subRX installed, and with SPLIT activated, VFO B will
control the transmit frequency.
Observe the 'arrow' on the right of the display which indicates which
VFO will be used for transmit. The VFO B cursor on the P3 is another
reminder of the TX VFO.
73,
Don W3FPR
On 10/4/2015 9:43 AM, [email protected] wrote:
>From the P3 manual"
"VFO A has a green cursor and VFO B has a magenta cursor unless split mode is
activated at the K3. In split mode, the VFO B cursor changes to red as a reminder that
you will transmit on that frequency."
Just to verify, is this true even without a sub-rx? In other words, with SPLIT
enabled (and no sub-rx) can I still move the cursor on the P3 for VFO-B with
the VFO-B knob on the K3?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
