As it turns out the issues are mostly related to my antenna and operator error... e.g. not knowing how to correctly use the DSP/AGC/Filters/RF gain.etc..
Rig is working 100% PEBKAC error ;) Jerry Moore CDXA, INDEXA, SKCC, Fists AE4PB, K3S - S.N. 010324 http://www.qrz.com/db/AE4PB An Amateur is - Considerate, Loyal, Progressive, Friendly, Balanced, and Patriotic. -----Original Message----- From: Elecraft [mailto:[email protected]] On Behalf Of dw Sent: Monday, October 12, 2015 2:03 PM To: [email protected] Subject: Re: [Elecraft] K3S Radio check? (signal generator) I used a simple 4-pin clock-oscillator running at 7.32mhz. Runs on 5VDC. Put it in a project box with LM7805 and a 12 inch wire as antenna. Can't use that as a signal generator for circuit tracing though without seriously limiting its output. But it makes for a simple little qrp xmitter. With nothing attached to K3 ANT1 input, lay the wire next to the K3. Picked up the signal S9. Hope you find the issue Jerry. -- [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
