I have a KX3 and a KXPA100, When I have the two connected as per the manual with the KXPA100 off, fldigi can connect to the KX3. As soon as I turn on the KXPA100 fldigi can no longer communicate with the KX3. How do I get fldigi to communicate to the KX3 with the KXPA100 powered up? It seems that this should be a lot easier than what I am making it.
My setup is: A laptop running Linux mint KX3 KXPA100 fldigi v3.23.03 using Hamlib I can connect without any trouble with both the KX3 utility and the KXPA100 utility. I was under the impression that both units used different command sets and that the KXPA100 would forward anything it does not recognize on to the KX3. Incidentally, I did try powering on the amp, then connecting with the KX3 utility, then closing the KX3 utility and launching fldigi. It would be really helpful for my education on the digital modes to be able to see the frequency I am using on the waterfall display. John Pitz KD8CIV ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
