Only one program can connect directly to a serial device like the K3.
You need to use a port sharing app like LP-Bridge or several others out
there to allow this to happen. LP-Bridge in this case connects to the
K3, and lets you create "virtual" ports for the SDR program, loggers,
etc. That way, each program thinks it's talking directly to the K3, but
in fact the virtual port traffic is routed and sequenced within the app
to get access to the K3 as needed.
Here's a link to my LP-Bridge web page...
http://www.telepostinc.com/LPB.html
Larry N8LP
On 10/15/2015 6:10 AM, [email protected] wrote:
Message: 24
Date: Thu, 15 Oct 2015 06:10:13 -0400
From: "David Smith"<[email protected]>
To:<[email protected]>
Subject: Re: [Elecraft] LP-PAN 2 and P3
Message-ID:<[email protected]>
Content-Type: text/plain; charset="iso-8859-1"
I have an additional question in addition to Jorge. I recently installed my
LPAN2 (I do not have a P3).
My question is that can I run my LPAN2 at the same time I run N1MM+. I
tried and got a port conflict the with K3. Also, I run SO2R with 2 K3s and
never made it that far to check additional port conflicts as I didn't make
it past the first port conflict.
Any comments appreciated.
David, ND4Y
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
