Here is how you can set up a programmable function key, say a hold of PF2, to toggle VFO LNK on and off: Hold CONFIG and tune VFO B to VFO LNK menu. Hold PF2. The display will say PF2 SET. Tap menu and now each hold of PF2 will toggle the link on and off. There are 10 programmable keys, holding PF1 and PF2, tapping M1 - M4, and holding M1 - M4. If you use an M1 - M4 keys you can't also use it for CW or SSB messages. Cheers, Fred
________________________________________ From: Elecraft <[email protected]> on behalf of William H. Hannon <[email protected]> Sent: Wednesday, October 21, 2015 9:45 PM To: [email protected] Subject: [Elecraft] Unable to Link V FO's (THANKS) Gentlemen: The only thing faster than change was the fast response from the group. That's what I get for updating the firmware last spring - after low band season and not paying attention. And thanks to Fred - as Patton said about Romel - I read your book (books). Now to re-read the part about Programmable Function keys.... Thanks to all 73, Bill N8PW : ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
