Hoop,
I do not have that Fred Cady book, but I would think that is intended
only to switch between the K3 and the KX3 when both the K3 and KX3 are
powered on.
If you want to operate the KX3 with the K3 powered off, you can remove
the cable from the K3 ACC connector.
73,
Don W3FPR
On 10/31/2015 4:53 PM, Jim Hooper wrote:
I have configured my K3 and KX3 as shown in “The Elecraft KX3 - Portable: Going for
the Summit” book that Fred wrote, the 2013 version. I have configured cabling as
shown in section "9.8 The KX3 and the KPA500”, figure 9.17, which shows use of
the Keyline Interrupter, RCA cables, E980232 Adapter for the KX3, et al, with an RF
switch between the K3 and KX3 in order to input either to the KAT500/KPA500 pair.
How do I put the KPA500 into OPER when I have powered off the K3 and switched
the my KX3?
Currently, when I turn off the K3, the KPA500 always switches to STBY and I can
not then switch the KPA500 from STBY back to OPER. I am thinking that there
might be a setting somewhere?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
