Gents,
in spring I made an upgrade to my K3 (#59xx) with the internal ATU
KAT3A. After this I guessed that there is a noise drop on all bands from
160 up to 10, but was not 100% sure. The strange thing: neighbor
stations with similar setup always gave much better reports than me, at
least 10 dB better. I was struggling a lot with my antennas, checked
coax every now and than etc. but everything was o.k. At that time my
main RX became suspicious.
Last week I bought a K3/10W (#39++) from a local ham as a backup here in
my shack. Comparing both rigs shows a huge difference in sensitivity.
Very weak signals, almost in the noise on 10 Meters are clearly audible
in the freshly bought K3 while there's almost nil on my old one. So i
fired up my HP8664A signal generator today and found my old K3 to be at
least 9dB worst compared to new one. This is for the main RX in my old
K3 while the second RX iny my old K3 is almost similar to the new K3
when fed through the AUX input (not through ANT 1!!).
So whats going on here? Something broken in my old K3 when I made the
upgrade with KAT3A? Wrong wired? I have no idea, perhaps you got one?
Udo, DK5YA
--
******************************************
Webs by DK5YA: *
http://www.mmmonvhf.de/ [editor]*
http://www.vhfdx.de/ [owner] *
http://www.palekastro.de/ [owner] *
http://www.solweb.de/ [owner] *
http://www.spessartwetter.de/ [owner] *
******************************************
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
