Don't power off the KX3 by abruptly killing the power to it -- make sure you power it off cleanly by simultaneously pressing those two buttons on the left before switching off the power supply, otherwise the settings won't get written to NV memory properly.
73, Matt VK2RQ On Sun, Nov 8, 2015 at 8:36 AM -0800, "Dauer, Edward" <[email protected]> wrote: Coordinating the KX3 with the KXPA100 requires setting PA Mode to ON in the KX3’s configuration menu. I noticed recently that when the system is powered down and later restarted, the PA Mode config had reset itself to OFF. The cabling was not disconnected – the only intervention was shutting down the power supply. Am I doing something wrong? The cabling is correct and employs the cable sets from Elecraft. Since the ON setting is required to get the two ATUs to behave properly, it’s an inconvenience to have to reset it to ON each time I power up . . . Any ideas? Thanks, Ted, KN1CBR ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
