On the control board, jumper J1 pin 1 to J2 pin 1, and J1 pin 2 to J2
pin 2. Reference is on the control board schematic diagram
73 de Stephanie
va3uxb
K2#5311 - K1#2132
On 11-Feb-2006, at 16.37.02, [EMAIL PROTECTED] wrote:
I am trying to tace a 2 x S point loss in my receiver. I want to
remove the
digital filter to remove that as a possibility. What pins on the
control
board do I put the jumpers - I cannot find this in the manual. I
am off on
holiday to Spain tomorrow and will take the K2 with me so that I
can work on.
Quick help appreciated
John G4BOU
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
