Josh,
You should not refrain from posting information about this amplifier and
its characteristics.
Perhaps I have monopolized the conversations with basic information
about RS-232 and its characteristics (and limitations), but I know
nothing about that specific amplifier. I can only talk about RS-232 and
its implications to the K3/K3S.
Since you have experience with that particular amplifier, then your
comments can be valuable. What did you do to make it work with the K3/K3S?
73,
Don W3FPR
On 12/15/2015 8:44 PM, Josh Fiden wrote:
The pins are normally pressed into the connector. If you can open it,
you can usually pull them out. That way you can test non-destructively.
OM2500A only uses RxD, TxD. It does not assert any other lines. RTS &
DTR are wired straight through, I haven't checked DSR & CTS for
continuity.
I can stop posting *correct* information about this amplifier at any
time, since it appears to be ignored. I thought it would be useful
since I actually *own* this amp and use it with a K3 and computer.
Apparently not!
73,
Josh W6XU
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
