Larry, Menu support for the UP and DN commands was unintentionally removed a long time ago. It was added back in as of rev. 5.33.
I tested your macros, and they work with the latest release (5.38), except that you need two "UP;" commands to go from FP mic to LINE IN. 73, Wayne N6KR On Dec 16, 2015, at 5:55 PM, Larry Boekeloo <[email protected]> wrote: > Hi everyone, > I have two Macros set up to change the audio input on my K3 from the front > panel to the Line In on the rear panel. > They worked fine until one of the latest big releases: > Macro 1: MNO53;DN;DN;DN;MN255: > Macro 2: MNO53;DN;DN;DN;UP;MN255: > Macro 1 sets the K3 to the mic connector on the front and Macro 2 sets the > input to Line In on the rear panel. > When I execute them, they come up to the display and I have to rotate the > dial to select the input. Previously, they just worked. > Any ideas? > Thanks. > Larry, KN8N > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
